![]() But I was thinking that if I was going to make a lot of these sets, then I would probably set up like four different routing stations for the different sides and really get an assembly line going. Also, I was very glad I had this sawstop pushstick or whatever you call it, because it made it a lot safer and more stable to route the short sides of all the pieces. And don't do them all in one batch, because it's really easy to get lost in thought when you have that many and the router can be such a dangerous tool if you don't pay close attention. So pretty monotonous work, so you want to make sure you have a good rigid position set up, don't be spontaneous when you have that many to do. ![]() There are 12 edges per piece, with a total of 54 pieces - in other words 648 passes. ![]() If not, they will not align to make a perfect square when stacked (like the original Jenga game). This is a particular length because you will want the length to match the width of three 2×4’s lying next to each other. Cut the 2×4’s into pieces that are 10 ½ inches long. So I pulled back a bit on the router, to just get them lightly routed.Īnother thing, this is a lot of routing. Directions for building a Giant Jenga: 1. And I did some tests, because I wanted the pieces routed, however I didn't want them to be so round so it was difficult to stand them up, if you were using these pieces as blcoks. And one thing about oak is it can be pretty splintery, and I didn't want to just sand the pieces because sometimes that doesn't remove all the splinters effectively, whereas the router does. Once I had the pieces cut up, I routed all the edges.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |